How To Nail 6 In Cedar Siding On

Simply go outside grab the lower edges of a siding course and try to slide it back and forth photo 1.

How to nail 6 in cedar siding on.

If clapboard isn t long enough to span a wall splice two together with a 45 degree scarf joint. Take care not to nail through the overlap of two pieces. Wider siding should be face nailed using two nails per piece. Siding up to 6 in.

Wrap the house with a polyethylene or similar moisture barrier stapled to the wooden wall sheathing with a construction stapler. Play at both ends so if it s nailed properly loosely you should be able to slide it 1 4 to 1 2 in. Place nail just above the overlap. In vertical application start at one corner with grooved edge toward the adjacent wall.

Do not reduce the siding overlap recommendations given in the installation sections of this. Manufacturers require about 1 4 in. This nail spacing allows each piece of siding to float. Install corner trim on all corners typically 1 by 4 inch boards nailed vertically with the wide face of a board.

In vertical application start at one corner with grooved edge toward the adjacent wall. Both t g and bevelled siding gets a fastener 3 4 above the top of the board below. If the overlap of the two pieces of siding is 1 1 4 inches then the nail for a piece of siding should be 1 3 8 inches above the bottom edge. The nail can be started with a normal carpenter s hammer and then made flush with the surface of the groove by means of a nail set.

Apply sealant to the ends fit them together and drive one nail through the overlapping board inch to the side of the joint. The idea is to avoid double nailing the board which will cause cracks when it shrinks. Wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue wider siding should be face nailed using two nails per bearing ring shank nails must penetrate 1 1 4 in into solid wood see figure 6. You can hand nail with galvanized casing nails but most builders use something like a bostich trim nailer for speed.

How to install cedar bevel siding. On the side of the building the roof angle was three pitch so we knew we had to cut our tongue and groove cedar boards at a 15 degree angle. Nails must penetrate 1 1 4 inches into solid wood. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe nailed through the base of each tongue.

If all the siding is tight it was installed wrong and should be redone.